Series 20 Carrier

Standard Equipment
. Aluminum or Steel Body

. Aluminum Body:
- High tensile 4 inch double-box extruded floor system
- Heavy duty extruded sill with integral full length graphite- impregnated wear strips top and bottom
- Front left and right chain trays
- 9 inch extruded double-box sides
- Front and rear sill reinforcements
- Heavy duty approach plate
- 6 chain locks
- smooth floor

. Steel Body:
- 3/16 smooth floor
- 4 x 2 structural tube crossmembers 12 inches on center
- Raised reinforced steel side rails
- 6 chain locks
- Full length body slide pads

. Full length reinforced rail subframe
. Fully hydraulic hitch or wheel lift
. Illuminated dual controls
. Body lock
. Mudflaps
. Federal standard 108 shock mounted lighting
. Tow light plug
. Water resistant junction box for wire harness connection
. Lubrication fittings on all pivot points
. 8,000 lb. hydraulic winch with 3/8 x 50 ft. cable
. Pilot operated holding valves on tilting and lifting functions
. Mechanical anti-tilt
. Backup alarm
. Cable roller guide/tensioner (8,000 lb. winch only)
. Winch free wheel extension (8,000 lb. winch only)
. Releasable L-arms
. Safety Chains


Optional Equipment

. Aluminum or Steel body
- Additional chain locks
- All steel or aluminium trimmed cab protectors
- Hydraulic planetary winch - 9,000 lbs.
- 8 cu. ft. water resistant aluminium tool box
- 4 cu. ft. aluminum tool box with shelf
- Factory installation
- Direct mount pump/PTO
- BackSaver wheel lift

. Steel Bodies Only
- 5, 6, 7.5 and 10 ton winches
- 3/16 deck plate
- 1/4 smooth or deck plate
- 5/4 Apitong wood floor
- Floor level sides with stake pockets
- Floor level sides with rub rails
- Open rail sides
- Open rail removable sides
- 4 x 2 structural tube crossmembers - 8 inches on center
- 102 inch wide body
Note: Some option selections may not be compatible in certain configurations.


Specifications

Steel Body Width

92 I.D. x 98 O.D.

Aluminum Body Width

92 I.D. x 96-3/4 O.D.

Body Extension

117 inches

Hitch Reach

41 inches

Wheel Lift Reach

64 inches

Control Valve

Sectional, 20 GPM, 1700 PSI

Oil Reservoir

12 gallons (low mount winch)
24 gallons (upright winch)

Oil Filter

250 PSI, 10 Microns

Pump

18 or 28 GPM

Winch

4, 5, 6 ton (low mount)
7.5 and 10 ton (upright)

Body Rating*

20,000 lbs. evenly distributed

Hitch Rating*

3,500 lbs. extended

Wheel Lift Rating*

4,000 lbs. extended

Cab Carrier Rating*

5,000 lbs. evenly distributed

Minimum Load Angle**

13 degrees at 35 inch frame height


* Load ratings are based on structural factors - not chassis capability.
** Load angle varies with frame height and carrier length. Lower frames and longer carriers will produce lower angles.